How Long to Read Approaches to Modeling of Friction and Wear

How Long Does it Take to Read Approaches to Modeling of Friction and Wear?

It takes the average reader 2 hours and 55 minutes to read Approaches to Modeling of Friction and Wear by Frederick F. Ling

Assuming a reading speed of 250 words per minute. Learn more

Description

At the conclusion of the Conference on Tribology in the area of Wear Life Pre diction of Mechanical Components, which was held at the General Motors Research Laboratories and sponsored by the Industrial Research Institute, a very high pri ority recommendation was modeling of tribological systems. Since the appearance of the Conference Proceedings in 1985, the writers discussed the matter of modeling with Dr. Edward A. Saibel, Chief of the Solid Mechanics Branch, Engineering Sciences Division, U.S. Army Research Office. This discussion led to a proposal for the Workshop which resulted in this volume. The choice of proposal and Workshop name turned out to be more restricted than it needed to be. As such, the Workshop adopted the name for this volume, Approaches to Modeling of Friction and Wear. By design, the attendance was restricted to not more than 40 individuals so as to allow small group discussions. There were four panels which deliberated on the same questions after two invited area lectures. Section 1 contains the substance of the two lectures. Section 2 is the Workshop Summary which is a distillation of the four panel reports by the entire Workshop attendance. This was formally written up and edited by the eight panel session chairmen, i.e., each of the four panels met twice on two different questions under the leadership of a chairman for each session. Section 3 contains four brief position papers on the subject of the Workshop.

How long is Approaches to Modeling of Friction and Wear?

Approaches to Modeling of Friction and Wear by Frederick F. Ling is 173 pages long, and a total of 43,769 words.

This makes it 58% the length of the average book. It also has 53% more words than the average book.

How Long Does it Take to Read Approaches to Modeling of Friction and Wear Aloud?

The average oral reading speed is 183 words per minute. This means it takes 3 hours and 59 minutes to read Approaches to Modeling of Friction and Wear aloud.

What Reading Level is Approaches to Modeling of Friction and Wear?

Approaches to Modeling of Friction and Wear is suitable for students ages 10 and up.

Note that there may be other factors that effect this rating besides length that are not factored in on this page. This may include things like complex language or sensitive topics not suitable for students of certain ages.

When deciding what to show young students always use your best judgement and consult a professional.

Where Can I Buy Approaches to Modeling of Friction and Wear?

Approaches to Modeling of Friction and Wear by Frederick F. Ling is sold by several retailers and bookshops. However, Read Time works with Amazon to provide an easier way to purchase books.

To buy Approaches to Modeling of Friction and Wear by Frederick F. Ling on Amazon click the button below.